Difference between revisions of "Guerrilla VoIP"
(updated with some useful info) |
(added Fritz!box voltage tests) |
||
| Line 20: | Line 20: | ||
[[image:phone_running_on_battery.jpg|right|400px|Cisco CP7940 running on a drill battery pack, shows 0.36A at approximately 12V]] | [[image:phone_running_on_battery.jpg|right|400px|Cisco CP7940 running on a drill battery pack, shows 0.36A at approximately 12V]] | ||
Tested the following items: | Tested the following items: | ||
| − | * Two Raspberry Pis on a drill battery pack (step-down) | + | * Two Raspberry Pis on a drill battery pack (step-down) |
| − | * Cisco CP7940 on a drill battery pack | + | ** uses 0.33A at approximately 12V |
| + | * Cisco CP7940 on a drill battery pack | ||
| + | ** uses something between 0.36A and 0.45A at approximately 12V | ||
| + | * Fritz!box has a switching regulator to 5V tested between 5.5V and 15V (drops off at 5.3V idle and elca at power supply segment is rated 16V) | ||
| + | ** without WiFi, it peaks at 0.44A (12V), and idles at about 0.34A-0.38, which the webservice is saying 41%-43%, which means it would top at about 0.88A. | ||
| + | ** With 15V power it idles at about 0.25A | ||
| + | |||
Still to test/measure: | Still to test/measure: | ||
| − | |||
* PoE switch at 48v | * PoE switch at 48v | ||
* whole set with battery and battery charger | * whole set with battery and battery charger | ||
[[Category:Telephony]] | [[Category:Telephony]] | ||
Revision as of 21:32, 3 July 2013
| Project: Guerrilla VoIP | |
|---|---|
| Featured: | |
| State | Active |
| Members | xopr |
| GitHub | No GitHub project defined. Add your project here. |
| Description | low cost communication node |
| Picture | |
| No project picture! Fill in form Picture or Upload a jpeg here | |
synopsis
Need to fill this with text when I have time..
Basic ingredients:
- sturdy compact waterproof (ammo) box
- battery, initially 7Ah (ordered)
- Fritz!Box router (NAT, FxS, FxO, DECT)
- Raspberry Pi running FreeSWITCH and DHCP
- Raspberry Pi running FreeSWITCH and TFTP
- (PoE) ethernet switch (ordered)
- Efficient power converter(s)
prototyping
Tested the following items:
- Two Raspberry Pis on a drill battery pack (step-down)
- uses 0.33A at approximately 12V
- Cisco CP7940 on a drill battery pack
- uses something between 0.36A and 0.45A at approximately 12V
- Fritz!box has a switching regulator to 5V tested between 5.5V and 15V (drops off at 5.3V idle and elca at power supply segment is rated 16V)
- without WiFi, it peaks at 0.44A (12V), and idles at about 0.34A-0.38, which the webservice is saying 41%-43%, which means it would top at about 0.88A.
- With 15V power it idles at about 0.25A
Still to test/measure:
- PoE switch at 48v
- whole set with battery and battery charger
