From Hackerspace ACKspace
|
|
| Line 1: |
Line 1: |
| − | {{Project
| + | #REDIRECT [[ESP8266]] |
| − | |State=Completed
| |
| − | |Members=Prodigity
| |
| − | |Description=Playing around with cheap wifi modules
| |
| − | |Picture=Runprogrun.JPG
| |
| − | }}
| |
| − | == synopsis ==
| |
| − | To make the ESP8266 more accessible to everyone [[User:Prodigity|Prodigity]] has created a "programmer" which allows for easy firmware uploading and communication with the [[ESP]]-01 module.
| |
| − | | |
| − | == Revision 1.1 ==
| |
| − | [[User:Xopr|xopr]] Modified the ESP^2 a bit:
| |
| − | * Added three wires (VCC, GND and GPIO2) for Dallas temperature sensor debugging (wire ends are insulated)
| |
| − | * Added pullup resistor was added so GPIO0 can be used after the device has been booted
| |
| − | * Added resistor to the 5V ESP^2 TX signal (should be two diodes I guess, the resistor divider didn't work)
| |
| − | | |
| − | == ESP-12 ==
| |
| − | Note that there are adapter board that give the ESP-12 a 0.1" pitch and includes the necessary resistors.
| |
| − | It would be handy, however, to have an adapter/socket like [http://www.ebay.com/itm/282505793123 this] or [https://www.thingiverse.com/thing:2163441/ this] with [http://www.ebay.com/itm/132235141457 these]
| |
| − | | |
| − | Location: [[Location::hACKspace]] (in the right 'solder cabinet')
| |
| − | [[Category:ESP8266]]
| |
Latest revision as of 09:36, 20 November 2021
