Difference between revisions of "Ant PCB Maker"
| Line 17: | Line 17: | ||
== Software installation == | == Software installation == | ||
| − | The instructions below were tested on Debian 10, with contrib, non-free and backports repositories enabled. | + | The instructions below were tested on Debian 10, with contrib, non-free and backports repositories enabled. <br/> |
| + | First, install the following required packages using the following command <br/> | ||
| + | <code>sudo apt update</code><br/> | ||
| + | <code>sudo apt instal git python-pip</code> | ||
=== Flatcam === | === Flatcam === | ||
=== bCNC === | === bCNC === | ||
| + | Run the following commands:<br/> | ||
| + | <code>sudo apt install python-tk</code><br/> | ||
| + | <code>pip2 install --upgrade bCNC</code><br/> | ||
| + | From now on, you can launch bCNC by running:<br/> | ||
| + | <code>python2 -m bCNC</code> | ||
Revision as of 22:39, 7 September 2019
| Project: Ant PCB Maker | |
|---|---|
| Featured: | No |
| State | Active |
| Members | Adnub |
| GitHub | No GitHub project defined. Add your project here. |
| Description | Creation of an Ant PCB Maker to prototype PCB design.
Also create needed manuals on how to operate it. |
| Picture | |
| |
Hardware completed. Documentation work in progress
Characeristics
- Maximum supported size of PCBs: 150mm x 80mm
- DC power supply: 12V 10A
Software used
- Flatcam 8.97 Beta
- bCNC
Software installation
The instructions below were tested on Debian 10, with contrib, non-free and backports repositories enabled.
First, install the following required packages using the following command
sudo apt update
sudo apt instal git python-pip
Flatcam
bCNC
Run the following commands:
sudo apt install python-tk
pip2 install --upgrade bCNC
From now on, you can launch bCNC by running:
python2 -m bCNC
