Difference between revisions of "ESP-2"

From Hackerspace ACKspace
Jump to: navigation, search
(added ESP reference)
m (added categories)
Line 16: Line 16:
 
== Todo ==
 
== Todo ==
 
Find a way to program the ESP-12 (2mm pitch) modules without much hassle (note that it needs a 10k resistor between GPIO15 and GND) to boot correctly
 
Find a way to program the ESP-12 (2mm pitch) modules without much hassle (note that it needs a 10k resistor between GPIO15 and GND) to boot correctly
 +
 +
[[Category:ESP8266]]

Revision as of 13:21, 27 August 2015

Featured article
ESP-2 had been flagged as a featured article and will automatically appear on the Main Page.
Project: ESP-2
Featured:
State Completed
Members Prodigity
GitHub No GitHub project defined. Add your project here.
Description Playing around with cheap wifi modules
Picture
No project picture! Fill in form Picture or Upload a jpeg here

synopsis

To make the ESP8266 more accessible to everyone Prodigity has created a "programmer" which allows for easy firmware uploading and communication with the ESP-01 module.

Behold, the ESP^2 (esp egg salad programmer).

Revision 1.1

xopr Modified the ESP^2 a bit:

  • Added three wires (VCC, GND and GPIO2) for Dallas temperature sensor debugging (wire ends are insulated)
  • Added pullup resistor was added so GPIO0 can be used after the device has been booted
  • Added resistor to the 5V ESP^2 TX signal (should be two diodes I guess, the resistor divider didn't work)

Todo

Find a way to program the ESP-12 (2mm pitch) modules without much hassle (note that it needs a 10k resistor between GPIO15 and GND) to boot correctly