Difference between revisions of "Avaya"
(created first draft on telephone howto) |
(No difference)
|
Revision as of 17:58, 2 January 2016
- only uses pins 1,2,3 + 6 (100Base-T)
- PoE compatible
- custom power module available: GND:pin 7, +48V:pin 8
- upon booting (about 20 seconds), the following message appears:
- 100 mbps ethernet (you might want to unplug the ethernet cable if the keys do not respond)
- * to program (after this step, you can plug in the ethernet connection again so you are able to type in the SIG command at the end)
- press *
- confirm every default with #
- at the end, it says "No new values. #=OK": confirm (8x)
- at the blank screen, type mute744# (Mute SIG#, you will notice a distinct short tick when pressing mute, and other keys being silent)
- change to SIP by cycling using * and confirm using #
