Difference between revisions of "ESP-2"
m (added location) |
|
(No difference)
| |
Revision as of 13:13, 19 July 2017
| Project: ESP-2 | |
|---|---|
| Featured: | |
| State | Completed |
| Members | Prodigity |
| GitHub | No GitHub project defined. Add your project here. |
| Description | Playing around with cheap wifi modules |
| Picture | |
| |
synopsis
To make the ESP8266 more accessible to everyone Prodigity has created a "programmer" which allows for easy firmware uploading and communication with the ESP-01 module.
Revision 1.1
xopr Modified the ESP^2 a bit:
- Added three wires (VCC, GND and GPIO2) for Dallas temperature sensor debugging (wire ends are insulated)
- Added pullup resistor was added so GPIO0 can be used after the device has been booted
- Added resistor to the 5V ESP^2 TX signal (should be two diodes I guess, the resistor divider didn't work)
Todo
Find a way to program the ESP-12 (2mm pitch) modules without much hassle (note that it needs a 10k resistor between GPIO15 and GND) to boot correctly
Location: hACKspace (in the right 'solder cabinet')
