Stoplichter

Project: Stoplichter
Featured:	No
State	Active
Members	Xopr, Stuiterveer
GitHub	stoplichter
Description	Hey 't is groen! Hey, nou is ie weer roze.
Picture
No project picture! Fill in form Picture or Upload a jpeg here

synopsis

Freely translated: traffic (scam) light.

Ingrediënten:

• verkeerslicht
• 3x3W RGB led

Resultaat:

new iteration

Since we have some things that speak ARTnet, it's time to upgrade the traffic light to give it 3 RGB pixels of ARTnet. The IP address is 192.168.1.114

Notes on the traffic light itself:

• the rubber gaskets wrap around the light, and are then placed from the outside with the thin seal wrapped around the flange like a reversed bicycle tire operation (it's fiddly)
• the current connector cabling is:

Some notes on the bitlair ART-net used for the LED sleeves:

• they listen to universe 0
• they don't start at address 0 but skip 4 pixels (offset 12)
• the first pixel is top right (looking at the simstrip, the last pixel on this grid is not used)
• the order of the ESP12 module of the pixels are (in RGB): 5, 4, 0; 2, 15, 13; 12, 14, 16: clockwise looking at the top, starting near the serial pins
• this translates on the PCB to (from left, screw terminal side to right):
  1. VCC (6.2V)
  2. 13 (B2)
  3. 12 (R3)
  4. 14 (G3)
  5. 16 (B3)
  6. 5 (R1)
  7. 4 (G1)
  8. 0 (B1)
  9. 2 (R2)
  10. 15 (G2)
  11. GND

todo

• some scripts for, say, spacestate
• creating a descent tapered pole OpenSCAD and .stl
  • the PVC tube parts (125mm and 100mm diameter) are in the stack space (in the cabinet's corner); they should be approximately 140cm and 75cm respectively.